Cat G3516H Combined Heat and Power (CHP) Solution

Standard Equipment

• Engine

  G3520H, V20, 4-stroke-cycle, gas engine. Operates on 31.5 to 47.2 MJ/NM3 dry pipeline natural gas. Turbocharged Separate Circuit Aftercooled.

• Control Panel

  On Package EMCP 4.3 Control Panel System Offers engine and generator monitoringand protection, voltage regulation with Cat IVRimproves transient response performance. Controls provide auto paralleling AGC-4 controller, load sharing, VFDcontrol, and primary generator protection for greaterversatility, package utilization and monitoring.

• Air Inlet

  Package Mounted Air Cleaner with service indicator

• Cooling

  ANSI/DN customer flange connections for JW inlet and outlet Engine driven water pumps for jacket water and aftercooler Jacket water and SCAC thermostats Standard cooling provides 40⁰C (104⁰F) ambient capability with 500mg/Nm3 NOx at 100% Continuous rating before derate, @ 500m

• Containerized Module

  NSPS Factory Compilant, UL2200 Compilant and CSA / TSSA Sound attenuated 75 dB(A) @ 7 m (23 ft) Sound attenuated air intake louvers and lockable personnel doors with panic release LH and RH engine service doors integrated intocontainer side walls 3” ANSI flange customer fuel connection

• Generator Controls And Protection

  Integrated crankcase ventilation system (CCV)and gas fuel train NFPA37 & CSAB149.3 with external fuel connections package utilization and monitoring.

• Modes Of Operation

  Provides for single unit stand-alone operation,island mode paralleling and load sharing withother power modules, and single unit-to-utilitymode paralleling for base load control

• Lube Oil Make-up System

  Integrated enclousre holding tanks: Oil makeup tank (50 gallon), Waste oil tank (300 gal / 2 oil changes), Fresh oil tank (500 gal / 2 oil changes + makeup) and oil level regulator. Low level annunciation

• Exhaust

  Externally mounted exhaust system (muffler and heat exchanger) Dry exhaust manifolds, insulated and shielded Individual exhaust port and turbocharger outlet wired to Integrated Tmeperature Sensing Module (ITSM) with GECM providing alarms and shutdowns Center section cooled turbocharger with Cat flanged outlet

• General

  Fire detection system

• Circuit Breaker

  LSI Long-Time, Short-Time, Instantaneous Annunciator 5000A 3-Pole IEC Rated Circuit Breakers Rear-mounted

• Fuel System

  Electronic fuel metering valve Throttle plate, 24V DC actuator, controlled by GECM

• Fuel System

  Fuel system is sized for 31.5 to 47.2 MJ/NM3 dry pipeline natural gas with pressure of 10.2 to 34.5KPa to the engine fuel control valve

• Ignition System

  Electronic Ignition System (controlled by ADEM A4) Individual Cylinder Detonation Sensitive Timing (DST)

• Generator

  Double bearing SR5 1866 frame, brushless, form wound, 12-lead design, permanent magnet excited, three-phase, with Cat IVR, Class H insulation operating at Class F temperature. Stator and Bearing temperature monitoring and anti-condensation space heaters. SR4B Caterpillar's Digital Voltage Regulator (CDVR) with 3-phase sensing and KVAR/PF control Paint- Caterpillar Yellow except rails gloss black Busbar connections Crankshaft Vibration Damper and Guard Parts book Reactive droop SR5 Anti-condensation space heater RH Service Operation and maintenance manuals Winding temperature detectors

• Govrerning System

  ADEM A4 4-20mA (0-5VV) Speed Input

Optional Equipment

• Air Inlet

  Mounting Brackets and Piping Air cleaner with precleaner

• Circuit Breaker

  Frame Mounting MP- Frame 6 Pole Bottom Cable Entry No UV trip or package mounted CB Wiring 4000/5000A Neutral Current Transformer Automatic Selection

• Control Panel

  Local alarm module Engine failure relay Remote PC Monitorring Remote Communications Module (PL1000T, PL1000E) Synchronizing module Local PC Monitorring Remote annuciator 16 Point/32 Light Annunciator, Shipped Loose Discrete I/O Module, 12 Digital Inputs, 8 'Form C' Relay Cat Connect: Ehternet, Satellite, Cell Telematics

• Cooling

  Coolant level drain line with valves, fan with guard Inlet/Outlet connections

• Exhaust

  Elbow Muffler and spark-arresting muffler with companion flanges Exhaust Expander Flexible Fitting Flange Oxidation catalyst

• Fuel System

  Gas pressure regulator Gas shutoff valve 24V, ETR (Energized-To-Run) Gas Knockdown Regulator Fuel filter

• Generator

  Manual voltage control Generator air filter Cable access box Medium and high voltage generators and attachment European bus bar Low voltage extension box Bearing temperature detectors

• Starting/charging

  Jacket water heater Battery with cables and rack (shipped loose) 24V starting motors 60A, 24V charging alternator (requires engine driven pumps)

• General

  Tool set Digital diagnostic tool US AID Emblem Special paint order Cold-weather bundle including enclosure heaters and ventilation recirculation Fire suppression system Interior DC lighting system with automatic shutoff timer