Your nearest location
EAST KNOXVILLE
865-546-1414
contact us
Home New Marine Generator Sets C18 (SRMP) Marine Generator Set

C18 Marine Generator Set

The C18 is the latest generator and brings commonality with our petroleum products as well as interfacing improvements. We have also taken this opportunity to add new price list options. All engine ratings and emissions certifications are the same, however we have been able to increase the power output of the generator for 12 of the 14 ratings.

Power Rating

Power Range 260 - 565 ekW

Generator Set Specifications

Frequency 50 / 60
Minimum Rating 260 ekW (325 kVA)
Maximum Rating 565 ekW (706 kVA)

Generator Set Configurations

Emissions EPA Tier 3, IMO II, EU IWW, EU Stage V, China II

Engine Specifications

Configuration In-line 6, 4-Stroke-Cycle Diesel
Aspiration Turbocharged - Aftercooled
Bore 5.7in
Stroke 7.2in
Fuel System MEUI
Oil Change Interval 250 / 500 hours
Governor Electronic
Refill Capacity 68
Cooling Heat Exchanger, Keel, Radiator Cooled
Rotation from Flywheel End SAE No. (136 teeth)

Generator Specifications

Excitation SRMP
Insulation Class H
IP Rating IP23 (standard), IP 44 (optional)
Voltage Regulator CDVR (Digital Voltage)

Generator Set Dimensions - Radiator Cooled

Height 94.8in
Length 55.6in
Width 66.9in
Weight - Approximate 13396lb

Generator Set Dimensions - Keel and Hex Cooled

Length 119.6in
Height 64.9in
Width 55.6in
Weight - Approximate 9747lb

Standard Equipment

  • Air Inlet System
    • Separate circuit after-cooled (SCAC)
    • Open Crankcase Ventilation (OCV) system
    • Turbocharger, jacket water cooled
    • Turbocharger inlet, 152 mm (6 in) OD straight connection
  • Cooling System
    • SCAC pump, gear driven, for HEX cooled engines only
    • Jacket water pump, gear driven
    • SCAC and JW shunt tanks for maintaining proper pump inlet pressures
  • Exhaust System
    • Water-cooled exhaust manifold & turbocharger
    • Round flanged exhaust outlet
  • Fuel System
    • Hybrid fuel line design
    • Fuel transfer pump, gear driven
    • Front service simplex fuel system
    • Manual fuel priming pump
  • Lube System
    • Center sump oil pan: Deep 500 hour oil change interval
    • Front and top service oil filler locations
    • Front service dipstick
  • Lube System
    • Oil pump, gear driven
  • Mounting System
    • Vibration Isolators
    • Formed C-channel rails
  • Control System
    • Common Interface to all Genset Control Panels
    • Programmable Low Idle
    • Electronic Diagnostics and Fault Logging
    • Electronic Fuel/Air Ratio Control
  • Control System
    • Programmable ECM Shutdowns for: High Jacket Water Coolant Temp Low Engine Oil Pressure Engine Overspeed

Optional Equipment

  • Exhaust System
    • Dry Elbows
    • Water-Cooled Elbows
    • Flexible Fitting
    • Flange
    • Muffler
    • Muffler, Spark Arresting
  • Air Inlet System
    • Air Inlet Adapter
  • Charging System
    • Battery Chargers 10 amp
    • Charging alternator 24V 105 amp
  • Control System
    • Caterpillar alarm and protection
    • EMCP 4.2 control panel
    • MGCP III B control panel
  • Fuel System
    • Duplex fuel filter – front service
    • Fuel cooler
    • Primary fuel/water separator
  • Instrumentation
    • Generator service side - LH, RH
    • Generator terminal box extension
    • Load sharing module (option for type approved module)
  • Lube System
    • Duplex oil filter
    • Sump pump
  • Protection System
    • Generator protection - IP44
  • Starting System
    • Starting motors - electric and/or air
    • Jacket water heaters