DG275-2 (3 phase)

Standard Equipment

• Cooling

  Factory-installed radiator 50/50 Ethylene glycol antifreeze Closed coolant recovery system Standard ambient temperatures up to 50°C (122°F) Radiator and cooling fan complete with protective guards

• Air Inlet

  Single element air filter

• Fuel	Primary and secondary fuel shut-off Low fuel pressure switch Fuel pressure test po Dual lock off valves NPT connection Natural Gas or LP Vapor

• Generator

  Class H insulation material Permanent magnet excitation Full load capacity alternator Permanent magnet excitation Integrated Voltage Regulator Class H insulation material Full load capacity alternator IP23 Protection Matched to the performance and output characteristics of Cat engines

• Exhaust

  Exhaust outlet with 3” pipe

• Controls

  EMCP 4.2 Series generator set controller

• Mounting

  Vibration isolaton (puck type) Rubber vibration isolators

• Electric Starting And/or Prelube

  Solenoid activated starter motor Engine electrical system Battery cables Solenoid activated starter motor

• Electric Power - Package Serial Number Prefix

  Battery charging alternator

• Governor

  Electronic governor (non adjustable)

• Control Panel

  EMCP 4.2 Series generator set controller

• Starting/charging

  Batteries with rack and cables 12 volt starting motor

Optional Equipment

• Starting/charging

  Charging alternator Jacket water heater Battery heater Battery charger – UL Listed 10 amp

• General

  Suitable for Use as Service Equipment (SUSE) CSA Certification Enclosures: sound attenuated, weather protective Automatic transfer switches (ATS) UL 2200 package

• Generator

  Anti-condensation heater Shunt trip and auxiliary contact breaker Thermal magnetic or electronic trip MCCBs Excitation: [ ] Permanent Magnet Excited (PM) Anti-condensation heater Oversize and premium generators