DG230-2 (3 phase)

Standard Equipment

• Cooling

  Factory-installed radiator Closed coolant recovery system 50/50 Ethylene glycol antifreeze Radiator and cooling fan complete with protective guards Standard ambient temperatures up to 50°C (122°F)

• Air Inlet

  Single element air filter

• Fuel	Low fuel pressure switch Primary and secondary fuel shut-off Fuel pressure test po Dual lock off valves Natural Gas or LP Vapor NPT connection

• Generator

  Class H insulation material Full load capacity alternator Permanent magnet excitation Class H insulation material Full load capacity alternator Integrated Voltage Regulator Matched to the performance and output characteristics of Cat engines Permanent magnet excitation IP23 Protection

• Exhaust

  Exhaust outlet with 3” pipe

• Controls

  EMCP 4.2 Series generator set controller

• Mounting

  Vibration isolaton (puck type) Rubber vibration isolators

• Electric Power - Package Serial Number Prefix

  Battery charging alternator

• Electric Starting And/or Prelube

  Battery cables Engine electrical system Solenoid activated starter motor Solenoid activated starter motor

• Governor

  Electronic governor (non adjustable)

• Control Panel

  EMCP 4.2 Series generator set controller

• Starting/charging

  Batteries with rack and cables 12 volt starting motor

Optional Equipment

• Starting/charging

  Battery heater Charging alternator Jacket water heater Battery charger – UL Listed 10 amp

• General

  Suitable for Use as Service Equipment (SUSE) Automatic transfer switches (ATS) CSA Certification Enclosures: sound attenuated, weather protective UL 2200 package

• Generator

  Anti-condensation heater Shunt trip and auxiliary contact breaker Thermal magnetic or electronic trip MCCBs Excitation: [ ] Permanent Magnet Excited (PM) Anti-condensation heater Oversize and premium generators