DG200-2 (3 phase)

Standard Equipment

• Cooling

  Closed coolant recovery system Factory-installed radiator 50/50 Ethylene glycol antifreeze Radiator and cooling fan complete with protective guards Standard ambient temperatures up to 50°C (122°F)

• Air Inlet

  Single element air filter

• Fuel	Primary and secondary fuel shut-off Low fuel pressure switch Fuel pressure test po Natural Gas or LP Vapor NPT connection Dual lock off valves

• Exhaust

  Exhaust outlet with 3” pipe

• Generator

  Permanent magnet excitation Full load capacity alternator Class H insulation material Permanent magnet excitation Integrated Voltage Regulator Matched to the performance and output characteristics of Cat engines Class H insulation material Full load capacity alternator IP23 Protection

• Controls

  EMCP 4.2 Series generator set controller

• Mounting

  Vibration isolaton (puck type) Rubber vibration isolators

• Electric Power - Package Serial Number Prefix

  Battery charging alternator

• Electric Starting And/or Prelube

  Battery cables Solenoid activated starter motor Engine electrical system Solenoid activated starter motor

• Governor

  Electronic governor (non adjustable)

• Control Panel

  EMCP 4.2 Series generator set controller

• Starting/charging

  Batteries with rack and cables 12 volt starting motor

Optional Equipment

• Starting/charging

  Jacket water heater Battery heater Charging alternator Battery charger – UL Listed 10 amp

• General

  Enclosures: sound attenuated, weather protective Suitable for Use as Service Equipment (SUSE) Automatic transfer switches (ATS) UL 2200 package CSA Certification

• Generator

  Thermal magnetic or electronic trip MCCBs Anti-condensation heater Shunt trip and auxiliary contact breaker Anti-condensation heater Excitation: [ ] Permanent Magnet Excited (PM) Oversize and premium generators