+
Your nearest location
EAST KNOXVILLE
865-546-1414
contact us
Home New Diesel Generator Sets C18 Generator Set

C18 Generator Set

Caterpillar is leading the power generation marketplace with Power Solutions engineered to deliver unmatched flexibility, expandability, reliability, and cost-effectiveness.

Generator Set Specifications

Maximum Rating 715 kVA
Minimum Rating 550 kVA
Emissions/Fuel Strategy Low Fuel, China Nonroad III Emis Stds
Voltage 380 to 415 Volts
Frequency 50 Hz
Speed 1500 rpm
Duty Cycle Standby, Prime

Engine Specifications

Engine Model C18 ATAAC, I-6, 4-Stroke Water-Cooled Diesel
Bore 5.71in
Stroke 7.2in
Displacement 1106.36in³
Compression Ratio 14.5:1
Aspiration Air to Air Aftercooled
Fuel System Electronic unit injection
Governor Type Ademâ„¢A4

Generator Set Dimensions

Length - Maximum 162.4in
Width - Maximum 78.3in
Height - Maximum 75in

Standard Equipment

  • Air Inlet System
    • Turbocharger
    • Light duty air cleaner
    • Aftercooler core
  • Air Inlet
    • Air cleaner
  • Control System
    • GCCP 1.2
  • Exhaust
    • Exhaust flange outlet
  • Cooling
    • Coolant drain line with valve
    • Caterpillar extended life coolant
    • Fan drive, battery charging alternator drive
    • Radiator and cooling fan with guard
  • Exhaust System
    • Stainless steel exhaust flex gaskets, raincap and SAE exhaust flange for customer use - shipped loose
  • Fuel
    • Secondary fuel filters
    • Fuel priming pump
    • Primary fuel filter with integral water separator
  • Fuel System
    • Standard 8 hour open set fuel tank
  • Generator
    • IP23 Protection
    • Load adjustment module provides engine relief upon load impact and improves load acceptance and recovery time
    • Matched to the performance and output characteristics of Cat engines
  • Generator And Attachments
    • Segregated low voltage (AC/DC) wiring panel
    • Integrated voltage regulator (IVR)
    • A Frame generator - IP21 protection
    • Integrated voltage regulator (IVR)
    • Mandatory option circuit breaker, IEC, 3 pole, mounted in power centre
    • Power center, IP22
    • Matched to the performance and output characteristics of Cat engines
  • Power Termination
    • Busbar
  • Governing System
    • Cat electronic governor (ADEM A4)
  • Control Panel
    • GCCP Genset Controller
  • Lube System
    • Lubricating oil
    • Oil drain valves
  • Mounting
    • Rubber vibration isolators
  • Mounting System
    • Captive linear vibration isolators between base and engine-generator. includes lifting provisions and termination points for coolant and lube oil drain lines
  • Starting/charging
    • 24 Volt battery with rack and cables
  • General
    • Engine and alternator pre-paint, Caterpillar yellow

Optional Equipment

  • Exhaust
    • Industrial, residential, critical mufflers
  • Air Inlet System
    • Dual element air cleaner
    • Single element air cleaner
  • Circuit Breakers
    • 3 Pole (IEC-100% rated) Circuit breakers - Motorised
    • 4 Pole (IEC-100% rated) Circuit breakers - Motorised
    • Circuit breaker (IEC) Auxiliary contacts
    • Padlockable circuit breaker device
    • 3 Pole (IEC-100% rated) Circuit breakers - Package mounted
    • 4 Pole (IEC-100% rated) Circuit breakers - Package mounted
    • Power terminal strip
    • Shunt trip for IEC breaker
  • Generator
    • Anti-condensation heater
    • Excitation: [ ] Permanent magnet excitation (PMG) Excited (PM) [ ] Internally Excited (IE)
    • Oversize and premium generators
  • Power Termination
    • Circuit breakers, IEC compliant
    • Circuit breakers, UL listed
  • Control Panels
    • Local & remote annunciator modules
    • Load share module
    • Remote monitoring software
    • EMCP (4.2) (4.3) (4.4)
    • Digital I/O module
  • Control System
    • Oil temperature displays
    • GCCP 1.5
    • Volt free contact
    • Protective devices: Earth fault relay - earth leageage Ground fault relay - Overload shutdown via breaker - Low fuel level alarm - Low fuel level shutdown - High fuel level alarm - Fuel level sensor
    • Local alarm modules
    • Remote annunciator module
    • Local alarm horn
  • Cooling System
    • Low coolant temperature alarm
    • Radiator duct flange
  • Starting/charging
    • Oversize batteries
    • Jacket water heater
    • Battery chargers
    • Heavy duty starting system
    • Charging alternator
  • Enclosures
    • Sound attenuated enclosures
  • Exhaust System
    • Manifold and turbocharger guards
    • Engine mounted muffler
    • 8 and 10 inch elbow kits
    • 8 and 10 inch GP flanges
    • 10, 25 and 35 end in / end outmufflers
  • Fuel System
    • Integral - Dual wall fuel tank base
    • Manual fuel transfer pump
    • Fuel transfer system
  • Generator And Attachments
    • LC frame generator
    • Permanent magnet excitation (PMG)
    • LC frame oversize generators
    • Space heaters
    • A Frame oversize generator
    • A Frame CIP generator
    • Ingress protection
    • LC frame CIP generator
  • General
    • Single or dual wall integral fuel tanks
    • UL 2200 package
    • Enclosures: Sound attenuated, weather protective
    • EU Certificate of Conformance (CE)
    • Integral & sub-base UL listed dual wall fuel tanks
    • Narrow, wide or skid base
    • The following options are based on regional and product configuration:
    • Seismic Certification per applicable building codes: IBC 2000, IBC 2003, IBC 2006, IBC 2009, CBC 2007
    • EEC Declaration of Conformity
    • CSA Certification
    • Sound attenuated, weather protective or high ambient weather protective enclosure
    • Automatic transfer switches (ATS)
    • Single or dual wall sub-base fuel tanks
  • Lube System
    • Manual sump pump
  • Starting And Charging
    • Jacket water heaters
    • 5 Amp Battery charger
    • Battery disconnect switch