C175-16 Generator Set

Standard Equipment

• Air Inlet System

  4 x Single element canister with service indicator(s).

• Control Panel

  2 Programmable relay outputs (Form C) Low coolant level Over/under voltage Coolant temperature Serial annunciator module data link Alarm acknowledge Text alarm/event descriptions Volts (L-L & L-N) Reverse power Over/under frequency Environmental sealed front face Programmable protective relaying functions Speed adjust Generator phase sequence Low coolant temperature Generator mounted - rear facing Overspeed Controls Frequency (Hz) Engine cycle crank Engine cool-down timer Warning/shutdown Indicators: Lamp test 2 Programmable digital outputs 6 Programmable digital inputs High coolant temperature Customer data link (Modbus RTU) Auto/start/stop control Emergency stop pushbutton RPM Digital Indicators Communications Accessory module data link Oil pressure (psi, kPa or bar) Low oil pressure Overcurrent Emergency stop 24 Volt DC operation 4 Programmable relay outputs (Form A) Failure to start (overcrank) True RMS AC metering, 3-phase, +/-2% accuracy Power factor (per phase & average) Operating hours DC volts Amps (per phase & average) Cat ECS 100 Reverse reactive power

• Exhaust System

  Bolted flange, with bellow for each turbo Exhaust flange outlet

• Fuel System

  Engine mounted filters #REF! Filters x 3 10 Micron spin on yype Secondary/tertiary fuel filters 4 Micron spin on type Primary fuel filter water/fuel water separator

• Generators And Attachments

  Right side extension box, bottom cable entry IEC platinum stator RTDs Reactive droop capability 3 Phase voltage sensing (MV) Busbar connections, right side extension box, bottom cable entry Class F temperature rise at 40C ambient Anti-condensation space heater NEMA Class H insulation 6 Leads Class H temperature rise at 40C ambient Voltage regulator Exciter diode monitor Form wound RFI suppression (LV) Busbar connections, top/center mounted, top cable entry 3 Phase brushless 60 Hz models: NEMA standard hole pattern Permanent magnet excitation (PMG) Min / max exciter limiter Salient pole

• Governing System

  Redundant shutdown (Overspeed protection through a duplicate speed sensing system) ADEM A4

• Lube System

  Oil filter, filler and dipstick Integral lube Oil cooler Oil drain lines and valve Fumes disposal Lubricating oil Prelube - required with prime, continuous, and standby Gear type lube oil pump

• Mounting Systems

  Rails - Engine/generator Rubber anti-vibration mounts - shipped loose Dual 24 volt electric starting motors Battery disconnect switch Batteries and battery rack w/cables

• Power Termination

  Busbar

• Service Instructions

  Two PM inspections

• General

  Paint - Caterpillar yellow with high gloss black rails & radiator SAE standard rotation LH Service Flywheel and flywheel housing-SAE No. 00

Optional Equipment

• Air Inlet System

  Air inlet adapters Dual element air cleaner Single element air cleaner Air inlet protection

• Control Panel

  Package mounted radiator Automatically selected ground Customer AC-DC connection mounting location - LV/MV Load share governor EMCP 4.4 E-Stop Frame boxes Annunciator modules Load share module / auxiliary plate and auxiliary box (LV) Fuel cooler Controller mounting location - LV/MV Modbus monitoring of packages Customer interface options EMCP 4.4 optional harness Controller voltage and current sensing groups Remote radiators Generator harness Interconnect harness Speed adjust Controller and MV and HV power connection locations Raise lower switch

• Crankcase Systems

  Explosive relief valves Crankcase ventilation system

• Exhaust System

  Mufflers Exhaust support group Weld flanges Exhaust collectors/manifold Front housing - Prime or continuous Front housing - Standby or mission critical Aftercooler drain

• Fuel System

  Primary fuel filter

• Generators And Attachments

  Low voltage - 1800 and 3000 Frames - 60 Hz, 3 phase, 1800 rpm, FW, PM, No of leads=6, Pitch 0.6667 Medium voltage - 1800 and 3000 Frames - 60 Hz, 3 phase, 1800 rpm, FW, PM, No of leads=6, Pitch 0.6667 Conversion GP - Top cable entry Low voltage - 1800 and 3000 Frames - 50 Hz, 3 phase, 1500 rpm, FW, PM, No of leads=6, Pitch 0.6667 Differential current transformers Space heater kit Medium voltage - 1800 and 3000 Frames - 50 Hz, 3 phase, 1500 rpm, FW, PM, No of leads=6, Pitch 0.6667 Thermostat for space heater Generator air intake

• Instrumentation

  Pyrometer and thermocouples

• Lube System

  Drain group oil pans Oil filters Lube oil heater Electric prelube pumps Lubricating oil

• Mounting Systems

  IBC vibration isolators - Shipped loose Spring type linear vibration isolators Rubber anti-vibration mounts

• Power Connections

  Low voltage connection cable Center post busbarss (LV) 1800 Frame generator side / rear mounted busbars (MV) Enclosures - Control packaging (LV) Paralleling circuit breakers 1800 Frame generators Circuit breaker Neutral ground (LV) Neutral ground (MV) Cable entry options (LV) Cable entry options (MV) Masterpack breakers Power connection covers (LV) Harnesses (Breaker) Masterpack breaker connections Side/rear mounted busbars (LV)

• Special Tests / Reports

  IBC seismic Certification Special test charge - Engine only PGS Test report @ 0.8 power factor Genset fuel consumption test Standard genset TVA (Torsional Vibration Analysis) report PGS Test report @ 1.0 power factor OSCOSH1 seismic Certification Custom generator TVA report Generator test report Standard engine test charge

• Starting / Charging System

  Heavy duty battery sets with rack Charging alternators - Dry Air pressure regulator Starter location covers 24 Volt power distribution box 24 Volt electric starting motor 35 Amp Battery chargers 24 Volt battery set - Dry 20 Amp Battery chargers Jacket water heaters 50 Amp Battery chargers Air starting motor Jacket water heater wiring groups

• General

  Special paint colors Control GP - air powered bar group Barring group manual Service tools - Engine barring group Engine barring air powered