+

3612 Generator Set (Medium Speed)

Caterpillar is leading the power generation marketplace with Power Solutions engineered to deliver unmatched flexibility, expandability, reliability, and cost-effectiveness.

Generator Set Specifications

Maximum Rating 4850 kVA
Minimum Rating 4400 kVA
Emissions/Fuel Strategy Low Fuel Consumption
Frequency 50 Hz
Speed 750 & 1000 rpm
Duty Cycle Prime, Continuous

Engine Specifications

Engine Model 3612 V-12,4-Stroke Water-Cooled Diesel
Bore 11in
Stroke 11.8in
Displacement 13524in³
Compression Ratio 13:01
Aspiration TA
Fuel System Direct unit injection
Governor Type Generator Set Monitoring System (GMS)

Generator Set Dimensions

Length - Maximum 404in
Width - Maximum 99.62in
Height - Maximum 156.6in
Dry Weight - Genset (maximum) 112690lb

Standard Equipment

  • Air Inlet System
    • Air cleaner
    • Turbocharger, watercooled, engine oil lubricated
    • Breather, crankcase, top-mounted
    • Aftercooler, fresh water, corrosion resistant coated (air side)
    • Air inlet shutoff
    • Air cleaner
    • Turbocharger, watercooled, engine oil lubricated
    • Breather, crankcase, top-mounted
    • Aftercooler, fresh water, corrosion resistant coated (air side)
    • Air inlet shutoff
    -->
  • Cooling System
    • Water temperature regulator
    • Engine coolant water drains
    • Jacket water thermostats
    • Front mounted turbos
    • Three-bundle oil cooler
  • Exhaust System
    • Dry, gas tight, exhaust manifold
    • 457 mm (18 in) Cat bolt pattern
    • Includes adapter, flexible exhaust fitting
  • Fuel System
    • Simplex or duplex
  • Generator System
    • Custom generator per generator data sheet completed by dealer
  • Governor System
    • UG Actuator
  • Lube System
    • Centrifugal oil filters with single shutoff
    • Oil filler and dipstick
    • Crankcase explosion relief valves
    • Oil pressure regulating valve
    • Wet oil sump. Includes engine-driven main lubrication and oil pumps, oil lines and oil pan
    • Service side engine mounted on cylinder block inspection covers
  • Mounting System
    • Damper, torsional vibration
    • Engine and generator mounting
  • Starting / Charging System
    • Line group for single point custom connection
    • Vane type air starter
    • Two motors, engine mounted at rear, on left side
    • Air silencer
  • General:
    • Paint, Caterpillar yellow
    • Gear driven pumps: Fuel/oil/jacket water/Aftercooler/Oil cooler water

Optional Equipment

  • Air Inlet System
    • Vertical support bracket
    • Soot filter
    • Boost control valve
    • Heavy duty air cleaner
    • Air cleaner louver assembly
    • Air inlet adapter
  • Cooling System
    • Heating aids
    • Auxiliary water pump
    • Expansion tank
    • Heat exchanger for single circuit
    • Cooling system aids
  • Exhaust System
    • Flexible exhaust fittings
    • Weld flange and related hardware
  • Fuel System
    • Duplex primary fuel strainer
    • Fuel system connections
    • Fuel priming pump
  • Generator System
    • Anti-condensation space heaters
    • Class F insulation
    • Busbar connections
    • Winding temperature detectors
    • 3 Phase, six Leads, WYE
  • Governor System
    • 230 UA
    • EGB actuator
    • Digital programmers
    • Electronic/actuators
    • 723 Plus
    • Battery backup/power supply
  • Lube System
    • Oil pan drain valve
    • Lube ANSI adapter (Emergency connection)
  • Mounting System
    • Spring type vibration isolators
    • Vertically restrained
    • Isolator
    • Non-vertically restrained
  • Starting / Charging System
    • Compressed air flex hose
    • Redundant air starters
    • Pressure reducing valve
    • Turbine type air starters
  • General:
    • Custom paint colors