3516E Low Voltage Generator Set

Standard Equipment

• Air Inlet System

  Single element canister type with service indicator Air cleaner

• Cooling

  Package mounted radiator

• Exhaust

  Exhaust flange outlet

• Fuel	Primary fuel filter with integral water separator Fuel priming pump

• Generator

  IP23 Protection Matched to the performance and output characteristics of Cat engines

• Power Termination

  Busbar

• Starting/charging

  Heavy duty starting system Charging alternator

• Control Panel

  Over/under voltage (27/59) Emergency stop pushbutton Speed adjust Accessory module data link Generator phase sequence Panel lights Alarm acknowledge Generator mounted - rear facing kW (per phase, average & percent) Engine cool-down timer Communications: High coolant temperature Warning/shutdown with common LED indication of shutdowns for: Overcurrent (50/51) Amps (per phase & average) Oil pressure (psi, kPa or bar) Serial annunciator module data link 24 Volt DC operation Cat ECS controller includes: DC volts Reverse reactive power (kVAr) (32RV) 6 Programmable digital inputs 2 Programmable relay outputs (Form C) Frequency (Hz) Customer data link (Modbus RTU) Power factor (per phase & average) kW-hr (total) Cat ECS 100 Lamp test kVA (per phase, average & percent) kVAr-hr (total) Coolant temperature Text alarm/event descriptions Over/under frequency (81 o/u) kVAr (per phase, average & percent) 4 Programmable relay outputs (Form A) Low coolant level True RMS AC metering, 3-phase, +/-2% accuracy Failure to start (overcrank) Operating hours Low coolant temperature 2 Programmable digital outputs Low oil pressure Controls: Digital indication for: Environmental sealed front face Overspeed Volts (L-L & L-N) Reverse power (kW) (32) Engine cycle crank Programmable protective relaying functions:

• Cooling System

  Fan and belt guards JWAC Radiator fan and fan drive Coolant level sensors Caterpillar extended life coolant Coolant drain line with valve

• Exhaust System

  Flanged faced outlet(s) Dry exhaust manifold

• Fuel System

  Fuel cooler; not included with packages without radiator Fuel priming pump Secondary fuel filters Flexible fuel lines - shipped loose

• Generators And Attachments

  Class H insulation, Class F temperature rise at 40C ambient (105C prime/130C standby) NEMA standard hole pattern Anti-condensation space heater Permanent magnet excitation (PMG) Form wound 3 Phase brushless, Salient pole 6 Lead Winding temperature detectors Right side extension terminal box, busbar connections, top mounted, bottom cable entry

• Governing System

  ADEM III

• Literature

  Parts book

• Lube System

  Gear type lube oil pump Integral lube Oil cooler Fumes disposal Oil drain lines and valve Oil filter, filler and dipstick Lubricating oil

• Mounting System

  Rubber anti-vibration mounts - shipped loose Rails - engine/generator/radiator mounting

• Starting / Charging System

  45 Amp Charging alternator Battery and battery rack w/cables Battery disconnect switch 24 Volt electric starting motor

• General

  Right hand servicing Paint - Caterpillar yellow with high gloss black rails & radiator SAE standard rotation Flywheel and flywheel housing-SAE No. 00

Optional Equipment

• Air Inlet System

  Air inlet protection Remote air inlet adapters Heavy duty air cleaners Dual element air cleaners

• Circuit Breakers

  2000, 2500, 3200, 4000 Amp, 4 Pole, IEC rated Circuit breakers Circuit breaker harnesses Masterpact breaker connections P Frame breaker connections 2000, 2500, 3200, 4000, 5000 Amp, 3 Pole, IEC rated Circuit breakers Busbar connections R Frame breaker connections Cable entry options 1600, 2000, 2500, 3000, 4000, 5000 Amp, 3 Pole, UL-100% rated Circuit breakers Optional busbar power connections

• Power Termination

  Circuit breakers, IEC compliant

• Control Panel

  Voltage raise/lower switch PC monitoring (Remote and local) Generator temperature monitoring Remote speed adjust Annunciator modules EMCP 4.4 Vandal proof panel door Auxiliary box Customer interface options Ground Language options Load share module options Mounting group - External box clips

• Cooling System

  Optional Serpentine radiators Optional ATAAC radiators Water level switch gauges Expansion tanks

• Exhaust System

  Flexible fittings Y Adapters Elbows Mufflers Flanges Flanges and exhaust fittings

• Fuel System

  Duplex fuel filters Primary fuel filters

• Generators And Attachments

  Differential current transformers - 8.7 and 15 kV class Alternator air cleaners

• Instrumentation

  Pyrometer and thermocouples

• Lube System

  Manual prelube pump Electric prelube pumps Oil level regulator Lube oil in standard sump

• Mounting System

  Spring type vibration isolators IBC Seismic vibration isolators NORAD Puck style low efficiency lsolators

• Power Connections

  Neutral ground connections 2700 & 3000 Frame Grounding groups

• Special Tests / Reports

  Fuel consumption test Torsional vibration analysis Standard engine test charge IBC Certifications Generator set consumption test Generator set test report PGS Test report @ 1.0 power factor PGS Test report @ 0.8 power factor

• Starting / Charging System

  Engine barring group 10, 20, 35 and 50 Amp Battery chargers Starter cover Jacket water heaters 24 Volt battery set - Dry Electric starting motors Air starting motors Air pressure regulator

• General

  US aid emblem Special paint colors