3516C Generator Set

Standard Equipment

• Air Inlet System

  Air cleaner; single element canister type

• Cooling

  Package mounted radiator

• Exhaust

  Exhaust flange outlet

• Control Panels

  Communications: Reverse reactive power (kVAr) (32RV) Customer data link (Modbus RTU) Generator mounted - rear facing 1 Programmable digital outputs Auto/start/stop control - Serial annunciator module data link Engine cool-down timer 24 Volt DC operation Controls: Generator set packages include Caterpillar's voltage regulator (IVR). IVR includes reactive droop capability, 3-phase voltage sensing, KVAR / PF modes, RFI suppression, min / max exciter. Limiter and exciter diode monitor Alarm acknowledge Cat connect Engine cycle crank Text alarm/event descriptions Overcurrent (50 / 51) Accessory module data link Cat ECS 100 1 Programmable relay outputs (Form C) Emergency stop pushbutton Speed adjust 4 Programmable relay outputs (Form A) Number of I/O varies on options selected 6 Customer programmable digital inputs Environmental sealed front face Load histogram feature Lamp test PLC functionality Customizable screens -0 True RMS AC metering, 3-phase, +/-2% accuracy Digital indication for: Operating hours RPM DC volts Frequency (Hz) Coolant temperature Volts (L-L & L-N) Oil pressure (psi, kPa or bar) Amps (per phase & average) kVAr (per phase, average & percent) kVA (per phase, average & percent) kW (per phase, average & percent) Power factor (per phase & average) kW-hr (total) kVAr-hr (total) High coolant temperature Overspeed Failure to start (overcrank) Warning/shutdown with common LED indication of shutdowns for: Emergency stop Low oil pressure Low coolant level Low coolant temperature Programmable protective relaying functions: Over/under frequency (81 o/u) Generator phase sequence Over/under voltage (27 / 59) Reverse power (kW) (32)

• Fuel	Primary fuel filter with integral water separator

• Generator

  Matched to the performance and output characteristics of Cat engines IP23 Protection

• Power Termination

  Busbar

• Control Panel

  Cat ECS Genset controller

• Cooling System

  Certified standard PGS provided

• Exhaust System

  Flanged faced outlet(s) Dry exhaust manifold

• Fuel System

  Flexible fuel lines - shipped loose Fuel cooler; not included with packages without radiator Secondary fuel filters Fuel priming pump

• General

  Caterpillar yellow with high gloss black rails and radiator Right hand servicing Flywheel and flywheel housing - SAE No. 00 Paint - Caterpillar yellow except rails and radiators gloss black SAE standard rotation

• Generator And Attachments

  Busbar connections, top center mounted, top cable entry Class H temperature rise at 40C ambient (125C prime / 150C standby) Low voltage: NEMA standard hole pattern Medium voltage: Anti-condensation space heater 6 Lead Random wound Form wound NEMA Class H insulation system, Class H temperature rise at 40C ambient (125C prime / 150C standby) Permanent magnet excitation (PMG) Class H insulation, Class F temperature rise at 40C ambient (105C prime/130C standby) Internal excitation (IE) 3 Phase brushless, Salient pole High voltage: Winding temperature detectors Busbar connections, right side extension box, bottom cable entry

• Governing System

  ADEM A3

• Literature

  Parts book

• Lubrication System

  Lubricating oil Fumes disposal Integral lube oil cool Oil drain lines and valve Oil filter, filler and dipstick Gear type lube oil pump

• Mounting System

  Anti-vibration mounts (shipped loose) Rubber anti-vibration mounts - shipped loose Rails - engine/generator/radiator mounting

• Starting System

  Battery disconnect switch 45 Amp Charging alternator 24 Volt electric starting motor Battery and battery rack w/cables

Optional Equipment

• Control System

  EMCP 4.4

• Exhaust

  Exhaust mufflers

-->

Air Inlet System

Single element filter Dual element air cleaner

Generator

Excitation: [ ] Permanent magnet excitation (PMG) Excited (PM) [ ] Internally Excited (IE) Oversize and premium generators Anti-condensation heater

Cooling System

Coolant Standard ambient ATAAC radiators Optional installed radiators Optional installed ATAAC radiators Standard ambient radiators Water level switch gauges

Power Termination

Circuit breakers, UL listed Circuit breakers, IEC compliant

Crankcase System

Explosion relief valves Ventilation system No explosion relief valves

Control Panels

Load share module Digital I/O module Generator temperature monitoring & protection Remote monitoring software

Mounting

Rubber anti-vibration mounts IBC isolators

Exhaust System

Y Adapters Flexible fittings Exhaust offset Tier 4 clean emissions module Elbows Flange and exhaust expanders Tier 4 clean emission MOD Kits Tier 4 dosing cabinet Flanges Mufflers Clean emission parts

Starting/charging

Oversize batteries Battery chargers Charging alternator Air starting motor with control and silencer Heavy duty starting system

Fuel System

Primary fuel filter

General

The following options are based on regional and product configuration: UL 2200 package CSA Certification EEC Declaration of Conformity Special paint (Colors other than Caterpillar yellow or high performance paints) Integral & sub-base fuel tanks US aid emblem Enclosures: Sound attenuated, weather protective Automatic transfer switches (ATS) Seismic Certification per applicable building codes: IBC 2000, IBC 2003, IBC 2006, IBC 2009, CBC 2007 EU Certificate of Conformance (CE) Integral & sub-base UL listed dual wall fuel tanks

Generators And Attachments

High voltage: 12470, 13200, 13800 volts, 3 phase 1800 rpm,FW, PM, No. of Leads = 6, Pitch = .6667: 2700, 3000 Frame High voltage: 6300, 6600, 6900 volts, 3 phase 1800 rpm, FW, PM, No. of Leads = 6, Pitch = .6667: 2700, 3000 Frame Thermostat for space heater Low / Medium voltage: 380, 440, 480, 600 volts, 3 phase 1800 rpm. RW, IE, No. of Leads = 6, Pitch = .6667: 1600 Frame Low / Medium voltage: 380, 416, 440, 480, 600, 2400, 4160 Volts, 3 Phase 1800 RPM, FW, PM, No. of Leads = 6, Pitch = .6667: 1600, 1800 Frame Differential current transformers (DCT) 8.7 kV and 15 kV classes Generator conversion Space heater kit Alternator air cleaner

Instrumentation

Pyrometer and thermocouples

Lubrication System

Oil level regulator Lube oil in standard sump Prelube pumps

Mounting System

Puck style low efficiency isolators Spring type vibration isolators IBC vibration isolators

Power Connections

Ground cables between generator and terminal box Neutral ground connections Left side power connections Center post busbars Right side power connections 2700 Frame, four lead, four terminal Rear power connections Low voltage Circuit breakers

Special Tests / Reports

IBC Certification Fuel consumption test Generator test report PGS Test report @ 1.0 power factor Torsional vibration analysis reports OSHPD Certification Generator set fuel consumption test PGS Test report @ 0.8 power factor Standard engine test charge Canadian Standards Association certification

Starting And Charging

Air pressure regulator Starter cover Air starting motors 10, 20, 35 and 50 Amp Battery chargers Electric starting motors Jacket water heaters 24 Volt battery set - Dry Engine barring device

Extended Service Coverage

Platinum, Gold and Silver coverage