3516 Diesel Generator Set

Standard Equipment

• Air Inlet System

  Air cleaner; single element canister type

• Air Inlet

  Air cleaner

• Cooling

  Package mounted radiator

• Exhaust

  Exhaust flange outlet

• Fuel	Secondary fuel filters Fuel priming pump Primary fuel filter with integral water separator

• Generator

  Matched to the performance and output characteristics of Cat engines IP23 Protection

• Power Termination

  Busbar

• Control Panel

  EMCP 4 Genset controller

• Control Panels

  Over/under voltage (27/59) Serial annunciator module data link Communications: Overcurrent (50/51) Over/under frequency (81 o/u Text alarm/event descriptions Generator set packages include Caterpillar's voltage regulator Programmable protective relaying functions: 4 Programmable relay outputs (Form A) Reverse power (kW) (32) Emergency stop Amps (per phase & average) Oil pressure (psi, kPa or bar) Operating hours 24 Volt DC operation Low oil pressure 6 Customer programmable digital inputs 1 Programmable digital outputs 1 Programmable relay outputs (Form C) Volts (L-L & L-N) Number of I/O varies on options selected RPM - DC volts Low coolant level kVAr-hr (total) Controls: Speed adjust - Auto/start/stop control - Engine cool-down timer - Engine cycle crank - Alarm acknowledge - Lamp test - Load histogram feature - PLC functionality - Customizable screens -0 True RMS AC metering, 3-phase, +/-2% accuracy kW-hr (total) Failure to start (overcrank) Environmental sealed front face Power factor (per phase & average) Accessory module data link Generator mounted - rear facing High coolant temperature Overspeed 3 Analog inputs Frequency (Hz) Warning/shutdown with common LED indication of shutdowns for Coolant temperature IVR includes reactive droop capability, 3-phase voltage sensing, KVAR / PF modes, RFI suppression, min /max exciter. Limiter and exciter diode monitor Customer data link (Modbus RTU) kVA (per phase, average & percent) Cat connect Generator phase sequence Reverse reactive power (kVAr) (32RV DC volts kW (per phase, average & percent) kVAr (per phase, average & percent) Emergency stop pushbutton Digital indication for: Low coolant temperature EMCP 4.2B

• Cooling System

  Certified standard PGS provided

• Exhaust System

  Flanged faced outlet(s) Dry exhaust manifold

• Fuel System

  Flexible fuel lines - shipped loose Fuel priming pump Fuel cooler; not included with packages without radiator Secondary fuel filters

• General

  SAE standard rotation Flywheel and flywheel housing - SAE No. 00 Right hand servicing Caterpillar yellow with high gloss black rails and radiator

• Generator And Attachments

  Medium voltage: Form wound Winding temperature detectors High voltage: 3 Phase brushless, Salient pole Permanent magnet excitation (PMG) Permanent magnet excitation (PMG) NEMA standard hole pattern Internal excitation (IE) Six lead Class H insulation, Class F temperature rise at 40C ambient (105C prime/130C standby) Low voltage: Winding temperature detectors NEMA standard hole pattern Form wound Winding temperature detectors Random wound Busbar connections, top center mounted, top cable entry NEMA Class H insulation system, Class H temperature rise at 40C ambient (125C prime/150C standby) Anti-condensation space heater NEMA Class H insulation system, Class H temperature rise at 40C ambient (125C prime/150C standby)

• Governing System

  ADEM A3

• Literature

  Parts book

• Lubrication System

  Gear type lube oil pump Fumes disposal Oil drain lines and valve Lubricating oil Oil filter, filler and dipstick Integral lube oil cool

• Mounting System

  Anti-vibration mounts (shipped loose) Rubber anti-vibration mounts - shipped loose Rails - Engine/generator/radiator mounting

• Starting System

  Battery disconnect switch Battery and battery rack w/cables 45 Amp Charging alternator 24 Volt electric starting motor

Optional Equipment

• Air Inlet System

  Dual element air cleaner Single element filter

• Exhaust

  Exhaust mufflers